CABLES AND INTERFACES:
LOUDSPEAKER INTERFACE CABLES
UNIQUE LOUDSPEAKER
DESERVE UNIQUE INTERFACES
The Genesis servo-controlled bass system employs an accelerometer as a sensor to constantly monitor the movement of the woofer cone and continuously compares it to the input signal. This comparison circuit identifies any deviation from the input signal and applies a corrective signal to compensate; resulting in the virtual elimination of the inherent distortion of the woofer.
In the Genesis products with an external amplifier, the servo-bass amplifier is driven by line-level input from the preamplifier. This means that while the midrange and tweeters of the speaker are driven by the power amplifier in use, the servo-bass amplifier is driven by the preamplifier.
This scheme of connection, while it works, may not be ideal. The power amplifier is never a “straight wire with gain”. Hence, it will affect the input signal in some way. The servo-system will correctly produce the bass part of the musical signal that is the input of the power amplifier, instead of the actual output to the speaker.
The Genesis Servo-Bass Interconnect Cable allows the balanced line-level input of the Genesis external servo-bass amplifier to be driven by the high-level outputs of your power amp – hence using the same signal that is driving the rest of the loudspeaker for an exceptional increase in transparency and bass coherence.
